DIY Shelving

Do you need shelving? Maybe you want to replace the flimsy plastic shelving left behind by the previous owners. Maybe you just need more organizing room. Or maybe you are short like me and would like custom shelving at just the right height. Don't go spend tons of money at the store on pre-made shelving. You can spend a lot less by doing it yourself.

We went to Lowe's and picked out a nice sturdy piece of particle board. Know what measurements you want and Lowe's will even cut the boards for you. This is especially helpful if you don't have a truck. We had them cut a 4 by 8 board into 8 pieces. Go the shelving section next and buy brackets. They are likely cheaper in bulk if you need a lot. We ended up putting up three for each shelf once we realized extra support was needed. Make sure the brackets are long enough to support your width of shelf. Also buy screws and wall anchors.

Determine where you want the shelves and make pencil marks where the brackets should go. Use a level to make sure your board will be even. Drill a hole in the wall for the brackets using a drill bit then hammer in your anchor and screw on the brackets. Sit your shelf on top and there you go! You are ready to organize. If you want you could paint your shelving before putting up the shelves. Covering them in fabric or scrapbook paper could also be fun and add some excitement to your closet.